Session handouts
One-page guides for each class meeting, plus the detailed Session 1 guides (brace stock and bridge) and the build spec sheet — the operations, key dimensions, checkpoints, and the permanent record that follows each ukulele. Print the current one before class, or pull it up on your phone at the bench.
-
Session 1 — Kickoff: brace stock + bridge Make the top brace set and the bridge — the build's two "bookends." Two operation handouts: brace stock (dimensions and planing) and bridge (jig workflow and shaping), plus a dimension drawing of the finished bridge and the build spec sheet that follows the ukulele through the whole build. The jigs used today — the brace-planing jig and the 3D-printed bridge jigs — live on the Jigs page.Brace stock PDF Bridge PDF Bridge drawing PDF Build spec sheet PDF
-
Session 2 — Join + thickness plates Join the top and back plates and thickness them to final dimension.Plates PDF
-
Session 3 — Brace the top Lay out the top bracing pattern and glue the top braces in the go-bar deck, or with clamps and cauls when the deck is busy.Session 3 one-pager Detailed top-bracing guide Alternative glue-up (clamps + cauls)
-
Session 4 — Brace the back Glue the back braces in the go-bar deck. Homework before Session 5: build the body mold and the wedge spreaders — see the Jigs page. You will need them for bending and lining.Back bracing PDF
-
Session 5 — Bend sides Bend the sides to shape — pick your method. Two handouts: bending-iron and side-bending jig.Iron method PDF Jig method PDF
-
Session 6 — Blocks, linings, rim Fit the head and tail blocks, install the linings, and true up the rim.Rim PDF
-
Session 7 — Close the body Close the body: glue the back and top to the rim, then trim the overhang.Close the body PDF
-
Session 8 — Fit neck + fretboard Clean up the body and fit the supplied neck and fretboard with the dowel joint.Neck fit PDF
-
Session 9 — Finish Sand, mask the fretboard and bridge areas, and apply the finish.Finish PDF
-
Session 10 — Bridge install + setup Glue the bridge and neck, let everything cure, then final setup to a playable instrument.Bridge + setup PDF